For FPV pilots, stick instructions are an important software for altering settings of your flight controller or FPV system straight out of your radio. These instructions permit you to carry out numerous capabilities, from navigating the OSD menu to trimming accelerometer, making them invaluable while you’re within the area with out entry to a pc. I’ll share the the stick instructions diagrams for Betaflight, iNav, and HDZero, so that you don’t must memorize them.
What Are Stick Instructions?
Stick instructions are particular combos of joystick actions in your radio that ship instructions to the flight controller (FC), enabling sure capabilities or activating the OSD menu.
Notice: All stick command diagrams on this information use Mode 2, the preferred radio configuration. For those who use a special mode, you’ll want to regulate the diagrams accordingly.
What’s Mode 2?
In Mode 2, the left stick controls throttle and yaw, whereas the proper stick controls pitch and roll. Study in regards to the fundamentals of radio right here: https://oscarliang.com/radio-transmitter/#Modes
Betaflight Stick Instructions
Essentially the most generally used Betaflight stick instructions embody:
- Enter OSD Menu: Maintain yaw left and pitch ahead.
- Accelerometer (ACC) Calibration: Maintain throttle up, yaw left, and pitch backward. That is helpful for those who can not carry out ACC calibration on a bench utilizing the configurator.
- Trim ACC: Use the 4 ACC trim instructions to regulate errors within the accelerometer. That is notably helpful in case your quad drifts in Angle or Horizon mode or for those who calibrated the ACC on an uneven floor.
Professional Tip: Guarantee you may have full stick journey to entry these instructions. Your stick endpoints ought to ideally be at 1000 and 2000, with the middle at 1500. If for no matter cause you’ll be able to’t get to those numbers, Betaflight means that you can change these values within the Receiver tab, simply regulate the “Stick Low,” “Stick Middle,” and “Stick Excessive”. However for most individuals the default values ought to work nice and don’t want altering.
iNav Stick Instructions
Most iNav stick instructions are much like Betaflight’s since each tasks originated from Cleanflight. Nevertheless, iNav introduces further instructions for navigation-focused capabilities:
- Load and Save Waypoint Missions: Distinctive to iNav, these instructions allow you to load or save pre-planned missions by way of the OSD menu while not having a pc.
- Compass Calibration: Throttle down, yaw proper, and roll left. You may use this command extra typically in iNav than Betaflight, particularly earlier than GPS-assisted flights to make sure correct navigation.
HDZero Stick Instructions
HDZero FPV system features a sequence of stick instructions for its video and OSD menu. These embody:
- Enter the HDZero OSD Menu: Entry and regulate settings particular to HDZero.
- Video Output Mode Change: Change output modes to regulate show preferences.
Conclusion: Why Stick Instructions Matter
Utilizing stick instructions in Betaflight, INAV, and HDZero unlocks a degree of comfort and management that enhances your total flight expertise. These instructions enable for fast tweaks while not having a pc, making them important within the area.